Panasonic P2HD AG-HPG20 Operating Instructions Manual page 34

Saving USER files on SD cards
Up to four sets of settings can be saved as four
files on the SD card, and they can be loaded from
the card.
• The menu setting value on the thumbnail display
screen cannot be saved or loaded.
1
Insert the SD card to the SD card slot.

Press [THUMBNAIL/MODE] to display the
normal display screen.

Press [MENU/MODE CHK].

Select "USER FILE" on the setting menu
"CARD FUNCTIONS", select "CHANGE",
and press .
• Basic operations on the setting menus (Page 88)
CARD FUNCTIONS
USER FILE
SD CARD FORMAT
5
Select "FILE SELECT", and press
6
PUSH MENU TO EXIT
Using or , select the file number (1 to ),
and press .
USER FILE (SD CARD)
FILE SELECT
READ
WRITE
FILE 1
FILE 2
FILE 3
FILE 4
TITLE RELOAD

Using and
USER FILE (SD CARD)
FILE SELECT
READ
WRITE
FILE 1
FILE 2
FILE 3
FILE 4
TITLE RELOAD

Display "YES" using
• In the figure below, "TITLE1" is the filename.
• After the data has been saved, "WRITE OK"
is displayed.
• The USER file which was written changes to
a white display.
USER FILE (SD CARD)
WRITE FILE 1
YES - - - - PUSH SET
NO
TITLE EDIT
TITLE1

RETURN
CHANGE
1
>>>
>>>
TITLE1
TITLE2
TITLE3
TITLE4
>>>
, select "WRITE", and press
1
>>>
RETURN
CHANGE
TITLE2
TITLE3
TITLE4
>>>
and , and press

Press [MENU/MODE CHK] four times to
display the normal display screen.
To give titles to files
1) Perform steps 1 to 7.
2) Select the characters using
move to the next character using
• The number of characters which can be input
is 8.
• Any of the following characters can be input.
(Space), A to Z, 0 to 9, : ; < = > ? @ [ \ ] ^ _ -. /
• All the characters can be deleted using the
unit's [RESET] button.
3) After all the characters have been input, press
at the left end of the characters (or
right end), display "YES" using
• After the data has been saved, "WRITE OK"
is displayed.
To load a file
1) Perform steps 1 to 6.
2) Move to "READ" using
. and press
• The files are loaded.
3) If "TURN POWER OFF" appears after loading,
turn off the power, and then turn it back on. The
loaded files are now set.
To reload the files from the SD card:
1) Perform steps 1 to 4.
2) Using
display "YES", and press
• The files are now re-loaded.
• If "WRITE NG FORMAT ERROR" is displayed,
.
format the SD card. (Page 33)
• If "WRITE NG WRITE PROTECT" is displayed,
release the SD card protection.
• If "WRITE NG CANNOT ACCESS" is displayed,
complete the other operations (such as playback),
and then proceed to operate.
• If "WRITE NG ERROR" is displayed, the SD card
may be defective. Replace the card.
.
and
and
.
and , move to "TITLE RELOAD",
.
, and
.
at the
, and press .
, display "YES",