Table of Contents
Advertisement
Before using
Quick Start
®iiiii
IIII_IIIIIIIIIIIIIIIII_IIIIIIIIIIIIIIIII_IIII_IIII_I_I_IIIII_IIIIIIIIIIIII_IIIIIIII_IIII_IIIIIIIIIIIIIIIIIII_IIIIIIII
iii_w_;
When Quick Start is ON the battery power is still
being consumed, even when the LCD Monitor
and the Viewfinder are closed.
The Camcorder
will resume recording/pause
mode about 1.7 seconds after the LCD Monitor
and the Viewfinder are reopened.
• Please note in Quick Start Mode approximately
half the pause recording power is being
consumed.
Using Quick Start Mode will reduce the battery
recording/playback
time.
• This is only activated in the following cases.
• While using the battery
A tape or a card is inserted while Tape
Recording Mode is set.
A card is inserted while Card Recording
Mode is set.
• While using the AC adaptor
Quick Start can be used even if a tape/card
is not inserted.
• Set to Tape/Card
Recording Mode.
1 Set [SETUP] >> [QUICK START] >> [ON].
(-2:r-)
2 While the [OFF/ON] switch
is still set to
[ON], close the LCD monitor
and retract the
Viewfinder.
OFF ON ®
• The Status indicator lights green and the unit
goes into quick start standby mode.
• The Camcorder
will not go into quick start
standby mode unless the LCD monitor is
closed and the viewfinder
is retracted.
3 Open the LCD monitor or extend the
Viewfinder.
OFF ON
• The Status indicator lights red and the
Camcorder
is put into recording pause
approx. 1.7 seconds after it is turned on.
•
To cancel
Quick
Start
1 Set [SETUP] >> [QUICK START] >> [OFF].
(-23-)
• If the [OFF/ON] switch is set to [OFF] while the
unit is in quick start standby mode, the power
turns off.
• If the standby continues for approx. 30 minutes,
then the Status indicator will go off and the
Camcorder
will be completely
turned off.
• In the following cases, quick start is canceled
and the power turns off.
• When the Mode dial is moved.
• When the battery or AC adaptor is removed.
• When both the tape and card are removed
while using the battery in Tape Recording
Mode.
• When the card is removed while using the
battery in Card Recording Mode.
• When the Camcorder
is quick-started
with the
white balance on automatic,
it may take some
time until the white balance is adjusted if the
scene being recorded has a light source
different from the scene last recorded. (When
the MagicPix function is used, however, the
white balance of the scene last recorded is
retained.)
• If the power is turned on in quick start standby
mode, the zoom magnification
becomes 1X and
the picture size may differ from what it was
before quick start standby.
• if [POWER SAVE] (-28-) is set to [5 MINUTES]
and the unit automatically
goes into quick start
standby mode, set the [OFF/ON] switch to
[OFF], then to [ON] again. Also, close the LCD
monitor and retract the viewfinder and then
open the LCD monitor or extend the viewfinder
again.
18
LSQT1121
Hide quick links:
Advertisement
Table of Contents
