Servicing The Engine Oil - Toro 74891 Operator's Manual

3. Remove the foam and paper elements
4. Remove the foam element from the paper element
(Figure 35).
Figure 35
1. Air-cleaner cover
2. Foam element
Servicing the Foam Element
1. Wash the foam element in warm water and detergent.
2. Rinse and allow it to air dry.
3. Lightly oil the foam element with new oil and squeeze
out excess oil.
Servicing the Paper Element
1. Gently tap the paper element to dislodge dirt.
Note: Do not wash the paper element or use
pressurized air, as this will damage the element.
Note: Replace a dirty, bent, or damaged element.
Handle the new element carefully; do not use if the
sealing surfaces are bent or damaged.
2. Clean the air-cleaner base as required, and check the
condition.
Installing the Elements
1. Install the foam element onto the paper element.
2. Install the elements onto the air-cleaner base
35).
3. Install the cover, and secure it with the latches
34).

Servicing the Engine Oil

Oil Type: Detergent oil (API service SJ or higher)
Crankcase Capacity: 1.9 L (64 oz) when the filter is changed
Viscosity: See the table below.
(Figure 35).
3. Paper element
(Figure
(Figure
0
0
Checking the Engine-Oil Level
Service Interval: Before each use or daily—Check the
engine-oil level.
1. Park the machine on a level surface, disengage the
blade-control switch, shut off the engine, and remove
the key.
2. Make sure that the engine is stopped, level, and is cool,
so the oil has time to drain into the sump.
3. Check the engine-oil level
A
D
C
F
31
SAE 30
50
g017552
Figure 36
(Figure 37).
B
E
G H
Figure 37
g027515