Adjusting The Motion-Control Levers; Pushing The Machine By Hand - Toro 74891 Operator's Manual

Adjusting the Motion-Control
Levers
Adjusting the Height
Note: Repeat the adjustment for the opposite control lever.
The motion-control levers can be adjusted higher or lower for
maximum operator comfort
A
g027252
Adjusting the Tilt
The motion-control levers can be tilted forward or rearward
for maximum operator comfort.
1. Loosen the upper bolt holding the control lever to the
control-arm shaft.
2. Loosen the lower bolt just enough to pivot the control
lever forward or rearward.
3. Tighten both bolts to secure the control in the new
position.
4. Repeat the adjustment for the opposite control lever.

Pushing the Machine by Hand

Important: Always push the machine by hand. Never
tow the machine because damage may occur.
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Engage the parking brake.
3. Move the motion-control levers outward to the
N -L position, shut off the engine, remove
EUTRAL OCK
the key, and wait for all moving parts to stop before
leaving the operating position.
4. Locate the bypass levers at the rear of the machine, on
the left and right side of the frame.
5. Move the bypass levers rearward and then down to lock
them in place to disengage the wheel motors
28).
(Figure 27).
B
Figure 27
Note: Ensure that the left and right bypass levers are
rearward and locked before moving the machine.
A
C
6. Disengage the parking brake.
Operating the Machine
Move the bypass levers to the position for operating the
machine (Figure
(Figure
24
B
D
Figure 28
28) to engage the wheel motors.
g027642