Servicing The Engine Oil - Toro 75930 Operator's Manual

Installing the Filters
Important:
To prevent engine damage, always
operate the engine with both air filters and the
cover installed.
1. If installing new filters, check each filter for
shipping damage.
Note:
Do not use a damaged filter.
2. If the inner filter is being replaced, carefully slide
it into the filter body
3. Carefully slide the primary filter over the inner
filter (Figure 47).
Note:
Ensure that the primary filter is fully
seated by pushing on the outer rim while
installing it.
Important:
Do not press on the soft, inside
area of the filter.
4. Install the air-cleaner cover and secure the
latches (Figure 47).

Servicing the Engine Oil

Oil Type: Detergent oil (API service SJ or higher)
Oil Capacity: with a filter change—1.9 L (2.0 US qt);
without a filter change—1.60 L (54.4 oz)
Viscosity: See the table below.
Figure 48
Note:
Use of synthetic oil having 5W-20 or 5W-30
rating is acceptable, up to 4°C (40°F).
Note:
Synthetic oils provide better starting in extreme
cold below -23°C (-10°F).
(Figure 47).
Checking the Engine-Oil Level
Service Interval: Before each use or daily
Note:
Check the oil when the engine is cold.
WARNING
Contact with hot surfaces may cause personal
injury.
Keep your hands, feet, face, clothing, and
other body parts away from the muffler and
other hot surfaces.
Important:
Do not overfill the crankcase with oil
because damage to the engine may result. Do not
run engine with oil below the Low mark because
the engine may be damaged.
1. Disengage the PTO, move the motion-control
levers to the N
engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position
g012991
40
-L position, and
EUTRAL OCK
(Figure 49).