Table of Contents
Advertisement
8
Quick-release axle in axle
holder
84
50 Nm
Tighten axle clamping
screws 2.
z
Clamping screws (quick-
release axle) in axle
holder
Tightening sequence: Tighten
each screw in alternate se-
quence three times
19 Nm
Tighten screws 1.
Wheel cover, front, to
forks
5 Nm
Removing rear wheel
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Install the rear-wheel stand
(
70).
Risk of burns from hot ex-
haust system.
Do not touch hot parts of the
exhaust system.
Slacken screw 1 of the clamp
and slip the clamp to the rear.
Do not remove the sealing
grease from the clamp.
Advertisement
Table of Contents
