Rear-Wheel Stand - BMW R nineT Rider's Manual

Adjust adapters 2 to the width
8
of the pins inserted in the front
suspension.
70
Set the height of the front-
wheel stand to raise the front
wheel far enough off the
ground to turn freely.
z
Engage the front-wheel stand
in the front suspension and
apply even pressure to push it
down to the ground.

Rear-wheel stand

Install the rear-wheel
stand
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Use the rear-wheel stand with
the rear axle adapters. The
rear-wheel stand and its ac-
cessory components are avail-
able from your BMW Motorrad
authorised dealer.
Use screws 1 to set the rear-
wheel stand to the desired
height.
Remove retaining disc 2. To
do so, press release button 3.
Push the rear-wheel stand from
the right onto the rear axle.
Push the retaining disc on from
the left, while holding the un-
lock button down.