Deactivation - BMW R nineT Rider's Manual

This function does not change
the status of the anti-theft alarm.
While an alarm is in progress an
alarm tone sounds and the turn
indicators flash. You can program
the type of alarm tone.
Reason for an alarm
Once you have deactivated the
alarm function, the DWA anti-
theft alarm status indicator is act-
ive for a period of one minute to
show you reasons for alarms, if
any, that were triggered in your
absence:
Flashes 1x: Motion sensor;
motorcycle was rocked forward/
back
Flashes 2x: Motion sensor;
motorcycle was rocked to the
side
Flashes 3x: Ignition switched
on with unauthorised key
Flashes 4x: Disconnection of
the DWA anti-theft alarm from
the motorcycle's battery
Information on alarm
triggering
If an alarm was triggered after
the last activation of the alarm
function, the rider is notified
accordingly by an alarm tone
sounding once when the ignition
is switched on.

Deactivation

with anti-theft alarm OE
Deactivating alarm
function
Press button 1 on the remote
control once or switch on the
ignition with an authorised key.
Note that you can deactiv-
ate the alarm function with
the ignition key only when the kill
switch is in the RUN position.
If the alarm function is de-
activated by the remote
control and the ignition is not
subsequently switched on, the
alarm function automatically goes
active again after 30 seconds if
5
47
z