Maintenance - TANACOM BULL 750 Operating Manual

Maintenance

Handling and maintenance of the power cord
Follow the restrictions below to avoid cord problems. Do not cut or connect your cord by yourself as it can cause
unintended problems.
Do not hang the reel
by the power cord.
Do not wash the power
cord.
Maintenance of the power cord
- Wipe the power cord with a wet cloth and dry it well.
- Pay special attention to drying the tips, with cover removed.
- Grease the connector after it is dried.
- Disconnect the power cord from the reel before storing.
Hold the connector, not the power cord, to pull the power
cord from the reel
Other maintenance points
- This reel is a precision instrument that employs electric circuity and motor. Do not disassemble the reel by
yourself.
- Cover the power connector on the reel with its protection cap.
- Old or worn cords can cause a bad connection and/or short circuit. Replace the cord every 2 years.
Clean and grease area A (pins) and area
B (Circumferential area).
B
A
5
Do not wind the power
cord around the reel
body with the connector
inserted into the reel.
Do not set heavy items
on the power cord, or
tie knots in the power
cord.