Auto Stop Setting - TANACOM BULL 750 Operating Manual

Functional setting operation

Auto stop setting

The Auto stop depth may be set to meet your own specific needs.
- Auto stop adjusts to operate at depths from 1 m to 5 m (in 10 cm increments).
- It prevents accidentally winding swivels, terminal rigs etc. into the rod tip and stops your rig at a consistent depth
for convenient checking and changing of baits and sinkers.
- Line stretch can cause an inaccurate reading at the surface. Simply reset the counter to zero at the surface.
1.
Connect the reel to the battery and press the
when the rig is right below the water surface.
The display shows 0.0.
2.
Raise the rod and adjust the line length from the rod tip so you
can reach the rig easily. In the figure, its length is 1.5 m.
Checking and changing sinkers, baits etc.
Use
3.
In this position, hold down the
for more than 2 seconds.
When blinks, this procedure is completed.
Default setting is 2.0 m. (Without pressing the
the winding stops at a depth of 5.0 m.
The lamp will blink when the setup has been completed.
4.
When taking in the rig by electric winding, it stops at a pre-set
point automatically.
Auto stop
Auto stop automatically brings your terminal rig to the surface, stopping consistently at your
pre-set depth preference. It eliminates the need to constantly monitor depth as it comes up.
- It stops automatically at the boatʼs edge when winding with the power lever, jigging (without a range setting), or
winding with the chumming timer.
- After the rig is ready, reset the depth counter to zero by pressing the
(water surface zero setting) (After this,
- Without pressing the RESET
- If you have pressed the
winding stops at 2 m.
- When auto stop depth is set, the alarm sounds every 2 m above the depth of 6 m, and winding stops at the set depth.
- After auto stop stops winding, the power lever can be used up to
such as, power lever and PICKUP, cannot be employed until the
- Depending on the rocking of the boat or sinker weight, auto stop depth can vary slightly. Should this happen, set
the auto stop position deeper.
(3. Auto stop function)
RESET BUTTON
INVERSE COUNTER BUTTON
RESET BUTTON
appears on the display)
BUTTON, winding stops at a depth of 5 m. (The
RESET BUTTON, the alarm sounds at 2m increments above the depth of 8 m, and
1
2
3
RESET BUTTON.
0.0 m. However, above
RESET BUTTON
21
1.5m
lamp is not displayed.)
0.0 m, motor winding
is pressed.