Inverse Counter - TANACOM BULL 750 Operating Manual

Functional setting operation

Inverse counter

Two counters are better than one. This reel has counters from both the surface and from the bottom.
-As the default setting of the inverse counter, it displays the measured winding speed during electrical winding.
If you want to use it as the inverse counter as in the previous model, turn on the inverse counter (See page 28).
In the following example, intended fishing range is 94 m, which is 6 m from the bottom.
5.
Clutch OFF (spool unlocked) to send the rig to the bottom.
(After water surface zero setting, see page 20.)
OFF
6.
At the bottom or when desired length of line is wound out,
move the clutch to ON by turning the reel handle or flipping the
clutch lever with your hand.
7.
At the bottom, after winding up any slack line, and when the
desired length of line is wound out, press the
COUNTER BUTTON to display
will be able to know the position of the rig in relation to the
position you set with the counter. (The figure shows that it is at
6 m above the position you have set as zero.)
-By pressing the
BUTTON,
accurate record of fishing time.
-You can wind the line electrically while pressing
Use
the PICK UP
8.
To pull up fish or the rig, you can stop the electric winding
automatically by setting any desired speed with the power
lever.
(6. Inverse counter)
ON
0.0 on the lower counter. You
INVERSE COUNTER
the timer starts and keeps an
BUTTON.
5
INVERSE
7
24