Hanging The Product On A Wall - Epson TM-T20II-i Technical Reference Manual

Hanging the product on a Wall

To hang the product on the wall, follow the steps below.
 To fix the product securely, hang the product on a wall made of wood, concrete, or metal.
 The thickness of the wall should be 10 mm or more.
 Be sure to use metallic screws.
 The screws on the wall side must have a pull-out strength of 150 N (15.3 kgf) or more.
1
Attach the included control panel label for vertical installation on the roll
paper cover.
2
Install 2 screws (screw diameter: 4 mm, head diameter: 7 to 9 mm) in the
wall at an interval of 80 mm.
Make sure the length of the screw's body in the wall is 10 mm or more, and the length outside
the wall is 3 to 4 mm.
32
Control panel label
for vertical installation