Network Setting - Epson TM-T20II-i Technical Reference Manual

Network Setting

There are following methods for network settings.
• EPSON TMNet WebConfig:
• Easy Setup:
This section briefly explains how to set from EPSON TMNet WebConfig.
Though Easy Setup requires no network connection during setup, you must specify values for
all the setting items available for EPSON TMNet WebConfig.
For about Easy Setup, refer to "TM-i Series Easy Setup Guide".
1. Connect via a wired LAN
Connect this product and a PC for setting via a wired LAN.
To use a wireless LAN, connect the wireless LAN unit to the USB port on this product.
2. Check the IP address of this product
When this product is turned on and becomes ready for printing, it prints out the automatically
acquired IP address.
If no IP address is printed, print a status sheet and check the IP address.
3. Start EPSON TMNet WebConfig
Access the address bar of the Web browser on the PC for setting to start EPSON TMNet WebConfig.
When SSL is disabled: http://[This product's IP address]/webconfig
When SSL is enabled: https://[This product's IP address]/webconfig
For detail, see "Starting EPSON TMNet WebConfig" on page
4. Set up TCP/IP
Select the [System Settings] menu and then [Wired] - [TCP/IP] or [Wireless] - [TCP/IP], and set
TCP/IP.
After setting, click [Apply] at the bottom of the screen. Then the settings are written to the product. If
[Apply] is not clicked, the settings are not applied.
For detail, see "System Settings - Network - Wired - TCP/IP" on page 104
Network - Wireless - TCP/IP" on page
56
Set from the computer's web browser
Set from the USB memory where the configuration file is stored.
106.
92.
or "System Settings -