Settings For Device Data Notification - Epson TM-T20II-i Technical Reference Manual

Settings for Device Data Notification

To use the device data notification function with this product, you need to make the following
settings using EPSON TMNet WebConfig.
• Set the ID for the input device
• Set the target server
• Set the print message output when an error occurs
You can use with TM-i firmware Ver.4.3 or later for this product.
This section gives an overview of the setup procedure.
1. Connect this product to the network
Connect this product to the network and turn on the power.
2. Start EPSON TMNet WebConfig
On the setup computer, enter the following into the address bar of your Web browser to start EPSON
TMNet WebConfig.
When SSL is disabled: http://[This product's IP address]/webconfig
When SSL is enabled: https://[This product's IP address]/webconfig
For details, see "Starting EPSON TMNet WebConfig" on page
3. Set the Device Data Notification
Make the necessary settings from [Device Data Notification] on the [Web Service Settings] menu.
After making settings, click [Apply] at the bottom of the screen. The settings are saved to this
product. Settings are not enabled unless you click [Apply].
For details, see "Web Service Settings - Server Access - Device Data Notification" on page
72
92.
103.