Prolonging Battery Life; Resetting Your Handheld - Palm Tungsten Tungsten T Handhelds Handbook

Handbook for palm tungsten t handhelds
Table of Contents

Advertisement

Appendix A Maintaining Your Handheld

Prolonging battery life

Note the following considerations for the battery in your handheld:
Under normal conditions your handheld battery should remain charged when
you place it in the cradle/cable for just a few minutes each day. You can
conserve battery life by doing any of the following:
– Turn off or reduce the brightness of the backlight feature. See
– Change the Auto-off setting that automatically turns the handheld off after
– Turn off the Bluetooth feature when you're not using it. See
– Minimize accessing the expansion card slot.
If the battery becomes low in the course of normal use, an alert appears on the
handheld screen, describing the low battery condition. If this alert appears,
perform a HotSync
in the cradle/cable to recharge the unit. This helps prevent accidental data loss.
If the battery drains to the point where your handheld does not operate, it stores
your data safely for about a week. In this case there is enough residual energy
in the battery to store the data, but not enough to turn on your handheld. If your
handheld does not turn on when you press the power button, you should
recharge the unit immediately. The battery may not have enough residual
energy to power the indicator light, which is normally green when the battery
is charging.
If your battery drains and you have the unit in an uncharged state for an
extended period of time, you can lose all your stored data.
There are no serviceable parts inside your handheld, so do not attempt to open
the unit.
If you ever dispose of your handheld, please dispose of it without damaging the
environment. Take your handheld to your nearest environmental recycling
center.

Resetting your handheld

Under normal circumstances you will not have to use the reset button. On rare
occasions, however, your handheld may no longer respond to buttons or to the
screen. In this case you need to perform a reset to get your handheld running
again.
242
backlight"
in
Chapter 2
a period of inactivity. See
information.
Preferences"
in
Chapter 17
®
operation to back up your data; then leave your handheld
for more information.
"Auto-off after"
in
for more information.
"Using the
Chapter 17
for more
"Bluetooth

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tungsten tungsten tTungsten t

Table of Contents