Cleaning Sprayer Exterior; Storage - Graco 16N664 Operation - Repair - Parts

Storage

Cleaning Sprayer Exterior

Wipe paint off outside of sprayer using a soft cloth moist
ened with water or flushing fluid. Do NOT submerge the
sprayer.
Storage
NOTICE
Failure to store sprayer with Pump Armor will result in
operational problems the next time you spray. Always
circulate Pump Armor through the sprayer after cleaning.
Water left in the sprayer will corrode and damage the
pump.
1. Lift prime/spray valve UP to the prime position.
Remove material cup and flexible suction tube.
ti16700a
2. Remove child-resistant cap. Thread nozzle onto Pump
Armor bottle. NOTE: For best results, make sure bottle
is full.
3A2853C
ti18879a
ti18869a
ti18870a
ti18067a
3. Hold sprayer upside-down over a waste container.
4. Insert Pump Armor nozzle over material inlet and push
firmly until it stops. Squeeze cleaning bottle until Pump
Armor flows out drain tube.
5. Remove Pump Armor nozzle and replace
child-resistant cap and tighten securely for storage.
6. Attach flexible suction tube and material cup. Push
valve DOWN to spray position.
ti18872a
7. Recharge battery to full charge before storage. See
Charging the Battery, page 6.
8. Store sprayer indoors in a cool, dry place. Store in
an upright position only. Never store sprayer with
material in the cup.
ti18862a
ti18066a
ti18069a
ti16701a
ti18871a
ti18885a
ti18177a
17