Battery and Charger
2.
Plug charger into an electrical outlet and slide battery into
charger as shown (light will turn on in 5 seconds).
Charger Status Indicator Lights
NOTE: When the charger is plugged in, the charger status indicator lights will alternate between green and red several times
before they turn off, indicating that the charger is ready to charge a battery.
Label
Appearance
Solid green light
ti25925a
Flashing green light
ti25926a
Flashing red light
ti25927a
Solid red light
ti25928a
Alternating green/red
lights
ti25929a
Sprayer Status Indicator Light
Light*
ti18884a
*NOTE: The sprayer status indicator light is only visible when sprayer trigger is engaged. You must squeeze and hold the trigger
to see the sprayer status indicator.
3A2853C
ti14990a
Indicates a full charge. Battery can be used.
Battery is charging, indicates 80% charge.
Battery can be used.
Battery is charging, indicates less than 80% charge. Do NOT use battery.
Battery is too hot or too cold to charge. Remove battery and allow to cool or warm
up before charging.
If flashing stops when battery is removed this indicates the battery needs to be
replaced. If flashing continues after battery is removed replace charger.
Appearance
No light
Normal operation.
Solid red
Battery is low on power and needs to be charged, or battery is too cold and
must warm up before spraying.
Flashing red
Battery temperature is too high, or spray tip is clogged.
See Troubleshooting, page 25.
3.
When battery becomes fully charged, immediately unplug
the charger from the power supply and remove the battery
from the charger.
Description
Description
7