Table of Contents
Advertisement
Storage
Cleaning Sprayer Exterior
•
Wipe paint off outside of sprayer using a soft cloth
moistened with water or flushing fluid.
Do NOT submerge the sprayer.
Tips
•
Tips will require replacement depending on
abrasiveness of paint.
•
Do not spray with worn tip. See Troubleshooting,
page 19.
Storage
NOTICE
Failure to store with sprayer with Pump Armor will
result in operational problems the next time you spray.
Always circulate Pump Armor through the sprayer
after cleaning. Water left in the sprayer will corrode
and damage the pump.
1. Dilute 120 ml (4 oz.) of Pump Armor Concentrate
with an additional 120 ml (4 oz.) of water in material
cup.
ti15442a
3A0885E
4 oz
2. Thread cup into sprayer, put control valve to UP
position and squeeze sprayer trigger for approxi-
mately 10 seconds.
ti14999a
3. Reverse spray tip to UNCLOG position, put control
valve DOWN to spray position, and aim sprayer into
waste area. Pull trigger for 1-2 seconds.
ti14991a
4. Properly dispose of used Pump Armor mixture from
material cup and rinse cup with water.
5. Store sprayer indoors in a cool, dry place. Store in
an upright position only.
NOTE: For prolonged battery life, lithium ion batter-
ies should be stored at half charge in an environ-
ment below 90° F (32° C).
ti15425a
ti15001a
ti15418a
17
Advertisement
Table of Contents
