Cleaning Sprayer Exterior; Tips - Graco 258870 Manual

Shutdown and Cleaning
7. Discard contaminated fluid and refill with appropri-
ate flushing fluid.
8. Disengage trigger lock, reverse tip to UNCLOG
position, and pull trigger for 5 seconds to prepare
sprayer.
ti14995a
9. Put control lever DOWN to spray position.
Trigger sprayer into waste area until no paint
appears in water or flushing fluid.
ti15425a
To avoid serious injury or damage to equipment, do not
expose the sprayer electronics to flushing solvents.
Keep sprayer at least 10 in. above the rim of the con-
tainer when flushing.
Keep spray area well-ventilated. Keep a good supply
of fresh air moving through the area.
10. Engage trigger lock and put control lever UP to
release pressure.
ti14994a
11. Remove material cup and discard used fluid.
3A0159A
12. Remove Spray Tip/Guard Assembly and clean with
water or flushing fluid. A soft brush can be used to
loosen and remove dried material if needed. Run
underwater and use a soft brush to clean the filter.
ti14991a
The tip is a permanently attached to the guard.
Removing the tip from the guard will result in damage
to tip assembly.
13. Replace tip assembly.
ti15491a 14. If you used the Fine-Finish Optimizer, remove and
clean optimizer with water (or flushing fluid) and a
brush. Reconnect intake tube.

Cleaning Sprayer Exterior

• Wipe paint off outside of sprayer using a soft cloth
ti15529a
moistened with water or flushing fluid.
Do NOT submerge the sprayer.

Tips

• Tips will require replacement depending on
ti14999a
abrasiveness of paint.
• Do not spray with worn tip. See Troubleshooting,
page 20.
ti15003a
NOTICE
ti15002a
17