Table of Contents
Advertisement
15. Place the Main PCB on the lower front cover.
16. Connect the FPC connector on the Main PCB.
17. Connect the SIM PCB on the Main PCB.
18. Place the lower back case on the lower front cover. Fit the lower front cover to the lower back case.
Close the four snaps making sure that both halves are connected.
19. Refit the four screws saved during disassembly.
20. Tighten the upper two screws to 2.9 kgf/cm and the lower two screws to 3.2 kgf/cm.
3.2 kgh/cm
2.9 kgh/cm
– 6-11 –
Advertisement
Table of Contents
