Table of Contents
Advertisement
9. Rotate and align the hinge pivot with the open area facing upward and carefuly insert the main area of the lower front cover,
taking care to tilt the upper cover assembly without causing damege to the flex circuit during reassembly.
10. Push down until the upper cover assembly is full engaged into the lower front cover.
Caution: Damage to the flex circuit portion of the upper flex PCB is not repairble. The flex circuit may be easily damaged during
this operation, causing a small tear which can grow with use and render the circuit unusable.
Open area of pivot
11. Set the phone into the "Open" position.
12. Insert the one push hinge into the lower front cover.
13. Set the phone into the "Close" position.
14. Place the hinge holder in the slot on the lower front cover and then push the hinge until locked in the position.
Hinge holder
– 6-10 –
Advertisement
Table of Contents
