Reset Button - Magnadyne RV5090 Operation And Installation Manual

Reset Button

The LCD display may fail to function normally due
to the vehicle's battery condition, and could require
resetting the radio microprocessor if:
• The vehicle has been "jump started" from a
dead battery condition.
• The vehicle battery becomes very low and is
quick-charged.
• The vehicle battery is removed and replaced.
Should any of these conditions occur, simply press
and release the RESET button on the radio front
panel using the tip of a ball point pen. This will reset
the radio microprocessor to the original factory
settings. After pressing the RESET button you
should recheck to see if the radio functions normally.
Additional Feature
Area Radio Frequency Adjustment:
Note: If operating the unit in the USA, do not
change the area.
To Change the Area:
1. Press the AM/FM button and "RADIO" appears
in the display.
2. Press and hold the VOL/TONE knob until
"SETUP" appears in the display.
3. Press the button and "US" or "OCEAN"
will be displayed.
4. Press the
setting to US or OCEAN.
5. Press the button to save the setting.
The unit will clear all the station settings.
After waiting a few seconds the unit
exit programming.
or button to change the
Reset Button
23