Table of Contents
Advertisement
USB Input (continued)
Disc File Selection:
Press the
l button to select a lower file.
��
Press the l
button to select a higher file. The
��
file number will appear in the display.
File selection can also be selected by using the
remote control. Press the file selection number
button that corresponds to the file you want to
play then press the ENTER button.
For example: If you want to play file 8, press but-
ton 8, then the ENTER button.
If you want to play file 28, press 10+, then press
button 2, followed immediately by button 8 and
finally press the ENTER button. File 28 will start
playing and "28" will appear in the display.
Pausing a MP3 Player:
Press the
ll button to "Pause" the player, press
�
it again to resume play.
Stopping a MP3 Player:
Press the
button to "Stop" the player. To
�
resume play, press the
Pressing the
button 2 times. Then press the
�
ll button and the disc will start playing from
�
the beginning.
Reset Button
The LCD display may fail to function normally due to the vehicle's battery condition, and could require
resetting the radio microprocessor if:
• The vehicle has been "jump started" from a dead battery condition.
• The vehicle battery becomes very low and is quick-charged.
• The vehicle battery is removed and replaced.
Should any of these conditions occur, simply press and release the RESET button on the radio front
panel using the tip of a ball point pen. This will reset the radio microprocessor to the original factory
settings. After pressing the RESET button you should recheck to see if the radio functions normally.
24
ll button.
�
File Number
MP3
PLAY
VOL
ZOOM
SETUP
TONE
+
ENTER
AS/PS
SLOW
ELAPSE
AUDIO
SUB.TT
BAND
EQ
2
3
1
DISP
6
7
4
5
10
8
9
10/0
+
PAUSE
Lower
ENTER
- IPOD -
MENU
HEADPHONE
OUTPUT
RESET
Higher
File Selection
Numbers
(Buttons 1-10+)
CD
ENTER
- IPOD -
MENU
HEADPHONE
OUTPUT
RESET
ENTER
- IPOD -
MENU
HEADPHONE
OUTPUT
RESET
Advertisement
Table of Contents
