Table of Contents
Advertisement
Headphone Output
Plugging in Headphone:
Insert a 3.5mm headphone jack into the
Headphone Output socket. Use the Volume knob
on the headphone to adjust the audio level.
Note: To make it so the sound only can be heard
through the headphones press the A, B, C but-
tons once to deselected speaker sets A, B and C.
The LED indicators for each speaker set will be off.
Reset Button
The LCD display may fail to function normally due
to the vehicle's battery condition, and could require
resetting the radio microprocessor if:
• The vehicle has been "jump started" from a
dead battery condition.
• The vehicle battery becomes very low and is
quick-charged.
• The vehicle battery is removed and replaced.
Should any of these conditions occur, simply press
and release the RESET button on the radio front
panel using the tip of a ball point pen. This will reset
the radio microprocessor to the original factory set-
tings. After pressing the RESET button you should
recheck to see if the radio functions normally.
Additional Feature
Area Radio Frequency Adjustment:
Note: If operating the unit in the USA, do not
change the area.
To Change the Area:
1. Press the AM/FM button and "RADIO" appears
in the display.
2. Press and hold the VOL/TONE knob until
"SETUP" appears in the display.
3. Press the
ll button and "US" or "OCEAN"
�
will be displayed.
4. Press the l
or
��
setting to US or OCEAN.
5. Press the
ll button to save the setting. The
�
unit will clear all the station settings. After wait-
ing a few seconds the unit exit programming.
l button to change the
��
Reset Button
25
Hide quick links:
Advertisement
Table of Contents
