Reset Button; Replaceable Fuse - Magnadyne M1-LCD Operation And Installation Manual

Reset Button

The LCD display may fail to function normally
due to the vehicle's battery condition, and could
require resetting the radio's microprocessor if:
• The vehicle has been "jump started" from a
dead battery condition.
• The vehicle battery becomes very low and is
quick-charged.
• The vehicle battery is removed and replaced.

Replaceable Fuse

If the fuse should blow, check that the wiring is correct. If the wiring is correct, replace the fuse with
the same amperage rating as the original (15 amp).
Should any of these conditions occur, simply
press and release the RESET button on the radio
front panel using the tip of a ball point pen. This
will reset the radio microprocessor to the origi-
nal factory settings. After pressing the RESET
button, you should recheck to see if the radio
functions normally.
15 Amp Replaceable Fuse
47