50Pth,Ptv, Ptd Start-Up Checklist - Carrier PTV Installation, Start-Up And Service Instructions Manual

CUSTOMER:
MODEL NO.:
50PTH,PTV, PTD
START-UP CHECKLIST
JOB NAME:
SERIAL NO.:
DATE:
PRE-START-UP
DOES THE UNiT VOLTAGE CORRESPOND WITH THE SUPPLY VOLTAGE AVAILABLE? (Y/N)
HAVE THE POWER AND CONTROL WIRING CONNECTIONS BEEN MADE AND TERMINALS
TIGHT? (Y/N)_
HAVE WATER CONNECTIONS BEEN MADE AND IS FLUID AVAILABLE AT HEAT EXCHANGER?
(Y/N) __
HAS PUMP BEEN TURNED ON AND ARE ISOLATION VALVES OPEN? (Y/N) __
HAS CONDENSATE CONNECTION BEEN MADE AND IS A TRAP INSTALLED? (Y/N) __
IS AN AIR FILTER INSTALLED? (Y/N) __
II. START-UP
IS FAN OPERATING WHEN COMPRESSOR OPERATES? (Y/N) __
IF 3-PHASE SCROLL COMPRESSOR IS PRESENT, VERIFY PROPER ROTATION PER INSTRUCTIONS.
(Y/N) __
UNIT VOLTAGE -- COOLING OPERATION
PHASE AB VOLTS PHASE BC VOLTS
(if 3 phase)
PHASE AB AMPS PHASE BC AMPS
(if 3 phase)
CONTROL VOLTAGE
IS CONTROL VOLTAGE ABOVE 21.6 VOLTS? (Y!N) __
IF NOT, CHECK FOR PROPER TRANSFORMER CONNECTION.
TEMPERATURES
FILL IN THE ANALYSIS CHART ATTACHED.
PHASE CA VOLTS
(if 3 phase)
PHASE CA MPS
(if 3 phase)
COAXIAL HEAT COOLING CYCLE:
EXCHANGER FLUID IN F FLUID OUT F
HEATING CYCLE:
FLUID IN F FLUID OUT F
AIR COIL COOLING CYCLE:
AIR IN F AIR OUT F
HEATING CYCLE:
AIR IN F AIR OUT F
PSI FLOW
PSI FLOW
CL-1