Snmp Host Table Settings - Fujitsu SH-E514TR1 10 User Manual

Group Name: Enter the SNMP group name to which the user belongs. The syntax is general string that does not
allow spaces.
SNMP V3 Encryption: Select the SNMPv3 encryption method. Options to choose from are None, Password, and
Key.
Auth-Protocol: Select the authentication level. Options to choose from are MD5, and SHA.
MD5 - Select to use the HMAC-MD5-96 authentication level. This field will require the user to enter a
password or a key.
SHA - Specify that the HMAC-SHA authentication protocol will be used. This field will require the user to enter
a password or a key.
Priv-Protocol: Select the private protocol. Options to choose from are None, and DES56.
None - Specify that no authorization protocol is in use.
DES56 - Specify that DES 56-bit encryption is in use, based on the CBC-DES (DES-56) standard. This field
will require the user to enter a password or a key.
Click Add to add a new entry based on the information entered.
Click Delete to remove the specified entry.

SNMP Host Table Settings

This window is used to configure and display the recipient of the SNMP notification.
The fields that can be configured are described below:
Host IPv4 Address: Enter the IPv4 address of the SNMP notification host.
User-based Security Model: Select the security model here. Options to choose from are SNMPv1, SNMPv2c, and
SNMPv3.
SNMPv1 - Select to allow the group user to use the SNMPv1 security model.
SNMPv2c - Select to allow the group user to use the SNMPv2c security model.
SNMPv3 - Select to allow the group user to use the SNMPv3 security model.
Security Level: When selecting SNMPv3 in the User-based Security Model drop-down list, this option is available.
NoAuthNoPriv - Specify that there will be no authorization and no encryption of packets sent between the
Switch and a remote SNMP manager.
AuthNoPriv - Specify that authorization will be required, but there will be no encryption of packets sent
between the Switch and a remote SNMP manager.
AuthPriv - Specify that authorization will be required, and that packets sent between the Switch and a remote
SNMP manger will be encrypted.
UDP Port: Enter the UDP port number. The default trap UDP port number is 162. The range of UDP port numbers is
from 0 to 65535. Some port numbers may conflict with other protocols.
Community String / SNMPv3 User Name: Enter the community string to be sent with the notification packet.
Click Add to add a new entry based on the information entered.
Click Delete to remove the specified entry.
SH-E514TR1 10 Gigabit Ethernet SmartPro Switch User Manual
Figure 8-10 SNMP Host Table Settings
29