Fujitsu s3-0801/1601 Installation Manual

The following instructions will help you
install and use your s3-0801/1601 KVM
switch easily.
Should you require further assistance, please
consult your installer/user guide.
NOTE:
You must turn off all servers that will be part
of your KVM switching system. Wait until step 4 to
turn on your target devices and KVM switch.
Connecting local peripherals
1
Locate your local peripherals. Plug your VGA, SVGA,
SGA or SXGA monitor or USB keyboard and mouse
cables into the corresponding local connection
ports.
Connecting a server to the switch
2
Choose a server port on the rear panel of the
switch. Plug one end of a CAT 5 cable, IQ module or
SMB Adapter module into a numbered port. If you
are using CAT 5 cable, plug the other end into the
RJ-45 connector of an IQ module.
The s3-0801/1601 switches support SMB
NOTE:
Adapter USB-VGA modules, as well as KVM
series2-Adapter modules.
Completing the connection
3
Plug your module into the appropriate ports on the
back of the server. Repeat this procedure for all
servers that will be connected to the switch.
Turning on targets and the switch
4
Locate the power cord that came with the switch
and plug the appropriate end into the power socket
on the rear panel of the switch. Plug the other end
into an appropriate AC wall outlet and then turn on
each target server.
Fujitsu Technology Solutions GmbH, User Documentation, 33106 Paderborn, Germany
All hardware and software names used are trademarks of their respective manufacturers.
installation
Quick Installation Guide
s3-0801/1601 KVM Switch
s3-0810/1601 switch configuration
4
Email - manuals@ts.fujitsu.com
l
3
1
switch shown
Ethernet
Online - http://ts.fujitsu.com/support
l
3
2
s3-1601
590-1036-640A