Table of Contents
Advertisement
Figure 33
1. Nozzle guides
Adjusting the Belt
Service Interval: After the first 8 hours
Every 50 hours
If the belt slips when changing the direction of the
nozzle, an adjustment to the belt is required.
1. Loosen the bolts securing the pulley mounting
bracket to the blower frame (Figure 34).
Figure 34
1. Belt
2. Pulley
2. Pivot the pulley mounting bracket away from the
nozzle until the desired belt tension attained.
3. Tighten the mounting bolts.
1
G017855
3. Mounting bolt
Inspecting the Tires
Service Interval: Every 100 hours
Operating accidents can damage a tire or rim, so inspect
tire condition after an accident.
Check the tire pressure frequently to ensure proper
inflation. If the tires are not inflated to the correct
pressure, the tires will wear prematurely.
Always replace worn or damaged tires with DOT
approved tires. See Figure 35 for the location of the tire
identification numbers.
Figure 36 is an example of tire wear caused by under
inflation.
1. Under inflated tire
Figure 37 is an example of tire wear caused by over
inflation.
1. Over inflated tire
27
Figure 35
Figure 36
Figure 37
Advertisement
Table of Contents
