Setting The Operational Mode To 802.1X - Avaya B189 Installing And Maintaining

Using local Administrative Menu procedures
Craft Procedure
value (in
English)
ADJUNCT
SETUP
DEBUG
GROUP
INT
LOGOUT
RESET VALUES
RESTART
PHONE
SSON
TEST
VIEW

Setting the operational mode to 802.1X

About this task
Use the following procedure to set or change the operational mode.
Procedure
1. When you select 802.1X from the Administrative Menu screen, the deskphone displays the
following:
802.1X Supplicant
The options that are displayed depend on the following parameters as set in the settings file:
• Disabled if DOT1XSTAT = 0
• Unicast-only if DOT1XSTAT = 1
• Unicast/multicast if DOT1XSTAT = 2
2. Tap the line you want to change.
A green tick mark is set next to the option that you have selected.
3. To change the setting, tap the option again.
4. Tap Save to store the new setting and redisplay the Administrative Menu screen.
Installing and Maintaining Avaya B189 IP Conference Phone
28
Craft Procedure Purpose
Manage the PA system
Enable/disable Debug Mode
Set the Group Identifier
Interface Control
Log off the deskphone
Reset system initialization values to
defaults
Restart the deskphone
Set the Site-Specific Option Number
Initiate a self-test
View current parameter values and
file names
Comments on this document? infodev@avaya.com
See
Managing the PA system
Enabling and disabling debug mode
page 31.
Changing The group identifier
Changing Ethernet interface control
page 33.
Loging off the deskphone
Resetting system values
Restarting the deskphone
Changing SSON settings
Performing a self-test on page 37.
Using The VIEW craft procedure for
troubleshooting on page 39.
on page 32
on
on page 33.
on
on page 34.
on page 35.
on page 35.
on page 36.
September 2015