Communication In The Press-To-Talk Mode; Communication By Using The Handset - Aiphone IS SERIES Operation Manual

■ Communication in the press-to-talk mode

(Available when "COMMUNICATION METHOD" is set
to "PTT" in the "INITIAL SETTING")
<When called in from a sub station>
1)
Press TALK momentarily.
After a beep, you can communicate in the press-to-
talk mode.
2)
Press and hold TALK to talk and release to listen to
the caller.
(When talking)
: Lit
3) When you have fi nished the communication, press
OFF .
Communication will end.
<When you received a direct voice call from
another master station>
Press and hold TALK to talk with and release to listen
to the caller.

■ Communication by using the handset

<In the hands-free mode>
1) Lift the handset and you can communicate with the
handset.
* You can also communicate in the press-to-talk
mode by pressing and holding TALK .
2) When you have fi nished the communication, put the
handset on the hook.
Communication will end.
20
(When listening to the caller)
: Off
<In the press-to-talk mode>
You can communicate in the press-to-talk mode by
pressing and holding TALK even when you are
communicating with the handset.
NOTE:
Communication will end automatically according to the set
communication time.
When two or more calls have arrived
1 Select a call to answer by following the steps 1) and 2)
below.
1) LIST .
Press
The list of calling sub stations is displayed.
2)
Press repeatedly so that the station no. (and/or
name) of the sub station you will select is highlighted.
* Calls from other master stations are not displayed
in the list.
2
Press TALK , ZOOM/WIDE
you can answer the call.
When the communication is fi nished, subsequent
*
incoming calls ring.
If you select another sub station while communicating,
*
the current communication is forcibly stopped, and then
you can answer the selected station with direct voice call
after a beep.
1
* : When you are receiving a direct voice call from another
master station, lifting the handset will not enable you to
communicate with the selected sub station. In that case,
press TALK or ZOOM/WIDE with the handset lifted.
About the priority
When receiving two or more functions (communication,
calling, paging, monitoring, etc.) at the same time,
depending on the priority setting, the order of priority for
them is as follows.
Priority Setting
1 (high) [URGENT], [BROADCAST]*
2 [PRIORITY]
3 [NORMAL]
4 (low)
Earlier call has priority over later call if the priority setting
*
is the same. When the communication path is occupied,
it is notifi ed by a sound.
* Communication takes priority over calling.
However, when a call with higher priority comes in, the
communication will be forcibly stopped.
With a master station, you can select the desired one
*
from the list of currently received calls, etc.
2
* : [BROADCAST]:
This can be selected only when you perform paging.
When [BROADCAST] is selected, you can perform
paging while interrupting all the other communications of
lower priority. In that case, no receiver can answer you.
NOTE:
When communication is stopped by receiving a higher priority
operation, a notice sound rings.
*1
or lift the handset , and
Function
2
Communication,
calling, paging,
chime paging.
- Monitoring, scan-
monitoring