Using The System; Receiving And Answeringa Call On The Master Station; Receiving A Call; Answering A Call - Aiphone IS SERIES Operation Manual

USING THE SYSTEM

RECEIVING AND ANSWERING A CALL ON THE MASTER STATION
The following describes the communication method using this system.

Receiving a call

Door station Room sub station
or
Press
Press
or
Lift the
handset.
1
The call tone rings, and the corresponding display
appears.
* The call tone from a sub station differs from the setting.
(→P. 15)
e.g.) When called from a video door station
The station no., station name and video image at the
calling station (following the station type image) are
displayed.
* It may take long until a video image appears on the
monitor.
* When an audio door station, room sub station or
another master station calls in, the station type image
is displayed. (The image differs from the calling station
type.)
* An incoming call from another master station will be a
direct voice call. (However, when the PRIVACY MODE is
set to "2", you will be notifi ed of an incoming call by the
display information and call tone.)
When you answer a call, the call tone of subsequent
*
incoming calls should be muted until you conclude the
fi rst call.
*1: LIST
Press to display the list of stations when two or more
calls have arrived. You can select the desired one and
start communicating with the caller. (→P. 20)
Another master station
or
(See page 31 for
how to call from a
master station.)
Lights up.
*1

Answering a call

The maximum duration of communication is preset in the
System setting. (It can be set to a maximum of 10 minutes.)
1 Answer the call in one of the following ways.

■ Communication in the hands-free mode

(Available when "COMMUNICATION METHOD" is set
to "HF" in the "INITIAL SETTING")
<When called in from a sub station>
1)
Press TALK momentarily.
After a beep, you can communicate in the hands-
free mode.
*1: When talking:
When listening to the caller:
2) When you have fi nished the communication, press
OFF .
Communication will end.
You can communicate in the press-to-talk mode by the
*
following operation even when "HF" is set (e.g., when
it is noisy around you).
• TALK for a few seconds while being
Press and hold
called. (Beeps twice and [PRIVACY] disappears
from the display.)
• TALK for more than one second
Press and hold
while communicating. (Beeps once and [PRIVACY]
disappears from the display.)
<When you received a direct voice call from
another master station>
You can talk back to it. If you press and hold TALK for
more than one second, it changes to the press-to-talk
mode. (Beeps once and [PRIVACY] disappears from
the display.)
*1
(Lit)
(Off)
(Continued on next page.)
19