Changing The Startup Sequence - IBM ThinkPad 760E Instruction Manual

Changing the Startup Sequence

Note:
You cannot set a hard disk drive
before a PCMCIA Card in the startup
sequence.
To change the startup sequence:
1
Start Easy-Setup and select the Start up icon.
2
Move the cursor to the Reset icon; then press the Spacebar.
3
Move the cursor to the icon for the first device in the startup
sequence; then press the Spacebar.
Repeat this step to set the other devices for the startup
sequence. You can set up to four devices.
4
Click on OK or press Enter to save the change.
Selecting the Network RPL Speed
When you use a remote program load through a token-ring card
or other network card, the RPL speed can be selected.
1
Start Easy-Setup and select the Start up icon.
2
Move the cursor to the Network icon; then press the
Spacebar.
The window to select the token-ring RPL speed appears.
3
Move the cursor to the 4 icon ( f or 4 Mbps) or the 16 icon
( f or 16 Mbps); then press the Spacebar and press Enter.
If you are using another card, such as an Ethernet card, you
do not need to specify the RPL speed, so press Esc to exit
this window.
Using Easy-Setup
Chapter 3. Operating Your Computer
39