IBM ThinkPad 760E Instruction Manual page 193

Note:
Because your CD-ROM drive is not
yet installed in the computer and
cannot be recognized automatically
by OS/ 2 Warp, you need to make
OS/ 2 Warp recognize the CD-ROM
drive.
Note:
If you have the OS/ 2 Warp FixPak
10 ( X R0010) or later, install it after
you complete the installation of OS/ 2
Warp. Follow the instructions in the
README.1ST file in diskette 1 of
that FixPak.
Avoiding Video Problems When Installing OS/ 2 Warp
b) Follow the instructions on the screen; however, pay
attention to the following during installation:
Select VGA as the Primary Display at the System
Configuration screen.
Select No Support Installed, not PCMCIA Feature, at
the System Configuration screen.
Select Non-Listed IDE CD-ROM for the CD-ROM at
the System Configuration screen.
c) When OS/ 2 Warp installation is complete, shut down OS/ 2
and turn off the computer.
d) Replace the diskette drive with the CD-ROM drive; then
turn on the computer.
The previous steps leave about 45MB of image files on your hard
disk drive. You can leave these files for future reinstallations, or you
can remove them to save hard disk space:
8
Clean up ( o ptional).
a) Open the OS/ 2 System folder; then open the Drives folder.
b) Open [ c :] drive; then click on the OS2IMAGE folder with
the right mouse button to bring up the folders menu.
c) Click on the Delete menu.
When you are asked to confirm deletion, select Yes.
If you have a video problem when installing OS/ 2 Warp, do the
following:
1
Make sure you have created the OS/ 2 Warp Video Fix Diskette
using the Diskette Factory program.
2
Start installing OS/ 2 Warp.
3
When prompted to remove OS/ 2 Warp Diskette 1 and restart
the computer, insert the OS/ 2 Warp Installation Diskette and
restart the computer instead.
Installing OS/ 2 Software
Chapter 7. Installing Software
175