Enhanced Video/ M Peg Feature Problems; Docking Station Problems - IBM ThinkPad 760E Instruction Manual

Troubleshooting

Enhanced Video/ M PEG Feature Problems

Problem
The Enhanced Video
function or the MPEG
function does not work.

Docking Station Problems

Problem
SCSI devices in the Dock
I or Dock II do not work.
The IDE CD-ROM drive or
hard disk drive in the
docking station
( S electaDock Docking
System, Dock I, or Dock
II) does not work.
246
IBM ThinkPad 760E, 760ED, or 760EL User's Guide
Verify the Enhanced Video is enabled and no resource conflicts ( I RQ or I/ O
address) exist by doing the following:
1. Select the Enhanced Video (
program.
2. Click on Advanced..., and make sure at least one IRQ is assigned for
the PCI devices.
If you find any conflicts with other devices, change the value to avoid
any conflicts ( s ee page 267).
The MPEG playback and the video capture functions use the same
hardware resources. Only one of the two functions can be used at the
same time. For the same reason, two MPEG functions cannot be used at
the same time.
Verify that:
SCSI devices are installed correctly. ( R efer to the user's guide for Dock I or
II.)
IRQ level for the SCSI controller does not conflict with the system resource.
– To change the SCSI IRQ, refer to the user's guide for Dock I or II.
– To change the system resource, click on the Docking Station (
icon in the ThinkPad Features program and click on Advanced and PCI
device setup; then change the IRQ level.
Verify that a secondary IDE device in the docking station does not conflict with
the system resource:
1. Start the ThinkPad Features program.
2. Click on the Docking Station (
secondary IDE device.
Cause and Action
) icon in the ThinkPad Features
Action
) icon and put a check mark by Enable
)