Installing The Thinkpad Features Program For Os/ 2 - IBM ThinkPad 760E Instruction Manual

Installing the ThinkPad Features Program for OS/ 2

Have the diskettes that came with the OS/ 2 system ready; then
install the CD-ROM device driver for OS/ 2 :
1
Start OS/ 2 Warp; then open OS/ 2 System, System Setup, and
then Selective Install.
2
Select the CD-ROM Device Support icon.
3
Select Non-listed IDE CD-ROM and click on OK.
4
Click on OK at the System Configuration screen.
5
At the OS/ 2 Setup and Configuration screen, select Install; then
follow the instructions on the screen.
For information about the software parameter in the CONFIG.SYS
file, refer to the README file in the CD-ROM Driver Diskette.
To install the ThinkPad Features program:
1
Start OS/ 2 Warp; then insert the Utility Diskette for OS/ 2 into
the diskette drive.
2
Install the ThinkPad System Management device driver:
a) Open OS/ 2 System and then System Setup.
b) Select Device Driver Install and click on the Install. . .
button.
c) Click on ThinkPad System Management Device Driver;
then click on OK.
3
Open the OS/ 2 screen command prompt.
4
Go to the A: prompt and type INSTALL2; then press Enter.
Follow the instructions on the screen.
5
Install the Windows ThinkPad Features program for the
WIN-OS/ 2 session:
a) Exit the OS/ 2 screen; then open a WIN-OS/ 2 full screen.
b) Follow the instructions in "Installing the ThinkPad Features
Program for Windows 3.11" on page 194.
Installing OS/ 2 Software
Chapter 7. Installing Software
177