Installing The Thinkpad Features Program; Installing For Os/2 - IBM ThinkPad 755CX Manual

Installing the ThinkPad Features Program

Installing the ThinkPad Features Program
Note:
To open the OS/2 full screen:
1. Double-click on OS/2 System.
2. Double-click on Command
Prompts.
3. Double-click on OS/2 Full
Screen.
PS2 command:
Page 41.
180
IBM ThinkPad 755CX User's Guide
When installing an operating system, you must install the ThinkPad
Features program that is on the Utility Diskette to set up the
programs used with your computer. Follow the instructions for your
operating system.
For OS/2, see "Installing for OS/2."
For DOS, see "Installing for DOS" on page 181.
For Windows, see "Installing for Windows" on page 182.

Installing for OS/2

OS/2
To install the ThinkPad Features program for OS/2, do the following:
1
Turn on the computer and start the operating system.
2
Install the ThinkPad System Management device driver.
a) Insert the Utility Diskette into the diskette drive.
b) Open the OS/2 full screen command prompt.
c) Type DDINSTAL; then press Enter.
d) Click on the Install... button.
e) Click on ThinkPad System Management Device Driver;
then click on OK.
3
Open the OS/2 full-screen command prompt.
4
Go to the
You have completed the installation of the ThinkPad Features
program.
Using PS2 command in OS/2 Environment
To use the PS2 command in the DOS session of OS/2, install the
program at the DOS full screen using the same procedure that you
used to install for DOS. (See page 181.)
Go to "Installing the PCMCIA Device Driver" on page 183.
prompt and type INSTALL2; then press Enter.