Using The Energy Save Mode - Konica Minolta BIZHUB 131f User Manual

Layout and installation
3.5.4

Using the Energy save mode

In order to conserve energy, your machine is initially set to be in the energy
save mode automatically when the machine is idle for approx. 5 minutes.
In Energy save mode, the machine stops pre-heating for printing and dis-
plays "Energy Save Mode" on the LCD. However, the LED lamps in the con-
trol panel and scanner lamp will not be off even when the machine is in the
energy save mode.
To recover from energy save mode, press any key in the control panel.
When your machine receives a fax message during energy save mode, the
machine will wake up automatically.
To change the Energy save mode setting:
1
2
3
4
Downloaded From ManualsPrinter.com Manuals
bizhub 131f/190f
Press [Menu], [2], [1], [0], [5], [Enter].
Press [,] or [+] to select "On" or "Off".
Press [Enter] to save the setting.
Press [Reset] to exit and return to the standby mode.
Note
The setting specifying the time until the machine enters Energy save
mode can be changed. Refer to "Idle time setting for switching to the En-
ergy save mode" on page 3-22" of "Entering Initial settings" on
page 3-18.
If you assign "Energy Save" to the soft key, you can switch your machine
to the Energy save mode immediately by pressing the soft key, regard-
less of the on/off setting and time setting. For details of the soft key, see
"Special features [CD]" on page 12-3.
3
3-23