Lubrication; Greasing Bearings And Bushings - Toro 07354 Operator's Manual

To install the hood, complete the following:
1. Connect the lights.
2. Insert the top mounting tabs into the frame slots.
3. Insert the lower mounting tabs into the frame slots.
4. Ensure that the hood is fully engaged in the top,
sides and bottom grooves.

Lubrication

Greasing Bearings and
Bushings
Service Interval: Every 100 hours (Lubricate more
frequently in heavy duty applications)
The vehicle has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease.
The grease fitting locations and quantities are as follows:
• Ball joints (4), tie rods (2), pivot mounts (2) and
steering cylinder (2) (Figure 33)
• Spring tower (2) (Figure 34)
• Clutch (1), accelerator (1), brake (qty. 1) (Figure 35)
• Accelerator arm (1) (Figure 36)
• U-joint (18) and 4 wheel drive shaft (3) (Figure 37)
Important: When greasing the drive shaft universal
shaft bearing crosses, pump grease until it comes
out of all 4 cups at each cross.
1. Wipe each grease fitting clean so foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into each bearing or bushing.
3. Wipe off excess grease.
34
Figure 33