Fuel System Maintenance; Fuel Lines And Connections; Servicing The Water Separator/Fuel Filter - Toro 07354 Operator's Manual

Industrial utility vehicle with bed
Table of Contents

Advertisement

4. Screw the filter on until the gasket contacts the
mounting plate, then tighten the filter 1/2 to 2/3 of
a turn. Do not overtighten.
5. Add oil to the crankcase; refer to Checking the
Engine Oil Level.
Fuel System
Maintenance

Fuel Lines and Connections

Service Interval: Every 400 hours/Yearly (whichever
comes first)
Every 1,000 hours/Every 2 years
(whichever comes first)
Inspect the fuel lines and connections for deterioration,
damage, or loose connections.
Servicing the Water
Separator/Fuel Filter
Draining the Water Separator
Service Interval: Before each use or daily—Drain water
or other contaminants from the water
separator.
1. Place a clean container under the fuel filter
(Figure 41).
2. Loosen the drain plug on the bottom of the filter
canister.
1. Water separator filter canister
3. Tighten the drain plug on the bottom of the filter
canister.
Changing the Fuel Filter Canister
Service Interval: Every 400 hours—Replace the fuel
filter canister.
1. Drain the water from the water separator; refer to
Draining the Water Separator.
2. Clean the area where the filter canister mounts
(Figure 41).
38
Figure 41

Advertisement

Table of Contents
loading

This manual is also suitable for:

Workman hdx-d

Table of Contents