Table of Contents
Advertisement
must not contact battery cover. Slide the rubber boot
over the positive terminal to prevent possible short–out
from occurring.
Warning
• Connecting cables to the wrong post could
damage the electrical system and result in
personal injury.
2
Figure 3
1. Positive (+) battery cable
Important
If battery is ever removed, make sure
battery clamp bolts are reinstalled with bolt heads
positioned on bottom side and nuts on top side. If clamp
bolts are reversed, they may interfere with hard lines when
shifting cutting units.
9. Coat both battery connections with Grafo 112X (skin
over) grease, Toro Part No. 505–47, petroleum jelly or
light grease to prevent corrosion and slide rubber boot
over positive terminal.
10. Install battery cover.
Check Angle Indicator
Danger
To reduce risk of injury or death due to rollover do
not operate on side hills steeper than 25 degrees.
1. Park machine on a flat, level surface.
2. Verify that the machine is level by placing a hand held
inclinometer (supplied with machine) on the frame
cross rail, by the tool box. The inclinometer should read
zero degrees, when viewed from the operator's position.
1
2. Negative (–) battery cable
1
1. Angle indicator
3. If inclinometer does not read zero degrees, move the
machine to a location where a zero degree reading is
obtained. The angle indicator, mounted on machine,
should now read zero degrees as well.
4. If angle indicator does not read zero degrees, loosen the
two screws and nuts securing angle indicator to
mounting bracket, adjust indicator to obtain a zero
degree reading and tighten capscrews.
Install Hood Latch
(European Compliance)
1. Unhook hood latch from bracket.
2. Slide hood lock bracket onto latch.
2
3
1. Hood latch
2. Hood latch bracket
3. Re–hook latch onto bracket.
4. Insert 1/4–20 x 1–1/2" lg. capscrew thru hood lock
bracket and secure with a capscrew, flat washer and
locknut.
14
Figure 4
1
Figure 5
3. Hood lock bracket
Advertisement
Table of Contents
