Fuel System; Bleeding Air From Injectors - Toro 03206 Operator's Manual

Traction unit
Hide thumbs Also See for 03206:
Table of Contents

Advertisement

Figure 54
1. Engine oil filter
3. Add oil to crankcase, refer to Check Engine Oil.

Fuel System

Danger
Under certain conditions, diesel fuel and fuel
vapors are highly flammable and explosive. A fire
or explosion from fuel can burn you and others
and can cause property damage.
• Use a funnel and fill the fuel tank outdoors, in
an open area, when the engine is off and is cold.
Wipe up any fuel that spills.
• Do not fill the fuel tank completely full. Add fuel
to the fuel tank until the level is 1 in. (25 mm)
below the bottom of the filler neck. This empty
space in the tank allows the fuel to expand.
• Never smoke when handling fuel, and stay away
from an open flame or where fuel fumes may be
ignited by a spark.
• Store fuel in a clean, safety-approved container
and keep the cap in place.
Fuel Tank
Drain and clean fuel tank every 2 years. Also, drain and
clean tank if fuel system becomes contaminated or if
machine is to be stored for an extended period. Use clean
fuel to flush out the tank.
Fuel Lines and Connections
Check lines and connections every 400 hours or yearly,
whichever comes first. Inspect for deterioration, damage, or
loose connections.
Water Separator
Drain water or other contaminants from water separator
(Fig. 55) daily.
1. Place a clean container under fuel filter.
2. Loosen drain plug on bottom of filter canister. Tighten
Replace filter canister after every 400 hours of operation.
1. Clean area where filter canister mounts.
1
2. Remove filter canister and clean mounting surface.
3. Lubricate gasket on filter canister with clean oil.
4. Install filter canister by hand until gasket contacts
1. Water separator

Bleeding Air From Injectors

Note: This procedure should be used only if fuel system
has been purged of air through normal priming procedures
and engine will not start; refer to Bleeding Fuel System.
1. Loosen the pipe connection to the No. 1 nozzle and
1. Fuel injectors (3)
39
plug after draining.
mounting surface, then rotate an additional 1/2 turn.
1
Figure 55
holder assembly.
1
Figure 56
2. Drain plug

Advertisement

Table of Contents
loading

This manual is also suitable for:

03207032200322103200 reelmaster 3100-d

Table of Contents