Table of Contents
Advertisement
Warning
Engine must be running so final adjustment of the
traction adjustment cam can be performed. To
guard against possible personal injury, keep hands,
feet, face and other parts of the body away from
the muffler, other hot parts of the engine, and
other rotating parts.
1
Figure 65
1. Traction adjustment cam
4. Start engine and rotate cam hex in both directions to
determine mid position of neutral span.
5. Tighten locknut securing adjustment.
6. Stop the engine.
7. Remove support blocks and lower the machine to the
shop floor. Test drive the machine to make sure it does
not creep.
Adjusting Parking Brake
Check adjustment every 200 hours.
1. Loosen set screw securing knob to parking brake lever.
2. Rotate knob until a force of 30–40 lbs. is required to
actuate lever.
3. Tighten set screw after adjustment has been attained.
2
2. Locknut
43
2
Figure 66
1. Parking brake lever
2. Knob
Battery Care
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
1. Battery electrolyte level must be properly maintained
and the top of the battery kept clean. lf the machine is
stored in a location where temperatures are extremely
high, the battery will run down more rapidly than if the
machine is stored in a location where temperatures are
cool.
2. Check the electrolyte level every 25 operating hours or,
if machine is in storage, every 30 days.
3. Maintain cell level with distilled or demineralized
water. Do not fill cells above the bottom of the split ring
inside each cell. Install filler caps with vents pointing to
the rear (toward fuel tank).
3
1
3. Set screw
Advertisement
Table of Contents
