Check Angle Indicator; Install Hood Latch (European Compliance) - Toro 03200 Reelmaster 3100-D Operator's Manual

1
Figure 6
1. Seat switch wire
7. On standard seat only, slide seat all the way forward,
pull wire to the right so unused connector is positioned
as shown in figure 7 and secure seat switch wire to rear
most hole in seat strap with a cable tie (cable tie
supplied with seat kit).
1
Figure 7
1. Seat switch wire
8. Mount seat straps to frame with fasteners previously
removed.
9. Slide seat completely forward and backward to ensure
proper operation and that seat switch wires and
connectors are not pinched or do not contact any
moving parts.

Check Angle Indicator

Danger
To reduce risk of injury or death due to rollover do
not operate on side hills steeper than 25 .
1. Park machine on a flat, level surface.
2. Verify that the machine is level by placing a hand held
inclinometer (supplied with machine) on the frame
cross rail, by the tool box. The inclinometer should read
zero degrees, when viewed from the operator's position.
2
2. Cable tie
2
2. Cable tie
15
1
Figure 8
1. Angle indicator
3. If inclinometer does not read zero degrees, move the
machine to a location where a zero degree reading is
obtained. The angle indicator, mounted on machine,
should now read zero degrees as well.
4. If angle indicator does not read zero degrees, loosen the
two screws and nuts securing angle indicator to
mounting bracket, adjust indicator to obtain a zero
degree reading and tighten capscrews.
Install Hood Latch
(European Compliance)
1. Unhook hood latch from bracket.
2. Slide hood lock bracket onto latch.
2
3
Figure 9
1. Hood latch
2. Hood latch bracket
3. Re–hook latch onto bracket.
4. Insert 1/4–20 x 1–1/2" lg. capscrew thru hood lock
bracket and secure with a capscrew, flat washer and
locknut.
1
3. Hood lock bracket