1. Negative (–) battery cable
Important: If you ever remove the battery,
install the battery-clamp bolts with the bolt heads
positioned on the bottom side and the nuts on the
top side. If the clamp bolts are reversed, they may
interfere with the hydraulic tubes when shifting
the cutting units.
9. Coat both battery connections with Grafo 112X (skin
over) grease (Toro Part No. 505-47), petroleum jelly,
or light grease to prevent corrosion.
10. Slide the rubber boot over the positive terminal to
prevent a possible short from occurring.
11. Install the battery cover.
2
Checking the Angle Indicator
Parts needed for this procedure:
1
Inclinometer
Procedure
1. Park the machine on a flat, level surface.
2. Verify that the machine is level by placing a handheld
inclinometer (supplied with the machine) on the frame
cross rail, by the fuel tank
Note: The inclinometer should read 0° when viewed
from the operating position.
Figure 4
2. Positive (+) battery cable
(Figure
5).
g031568
1. Angle indicator
3. If the inclinometer does not read 0°, move the machine
to a different location to obtain a 0° reading.
Note: The angle indicator, mounted on the machine,
should now read 0° also.
4. If the angle indicator does not read 0°, loosen the 2
screws and nuts securing the angle indicator to the
mounting bracket, adjust the indicator to obtain a 0°
reading, and tighten the bolts.
12
Figure 5
g031569