Mount Carrier Frames To Cutting Units - Toro 03206 Operator's Manual

5. Remove rear retaining rings securing mounting pins to
each end of lift cylinder.
1
4
6
5
Figure 10
1. Lift arm (R.H.)
2. Lift arm (L.H.)
3. Retaining ring
6. Secure right end of lift cylinder to right lift arm with pin
and (2) spacers. Secure with retaining ring.
2
3
1
Figure 11
1. Lift cylinder
2. Hoses
7. Secure left end of lift cylinder to left lift arm with pin.
Secure with retaining ring.
Note: With lift arms fully raised, hoses should be routed as
shown in figure 14 and clear lift arm by .04–.12".
3
2
4
4. Mounting pin
5. Lift cylinder
6. Spacer (2)
3. Clearance here
Mount Carrier Frames To
Cutting Units
1. Remove cutting units from cartons. Adjust per Cutting
Unit Operator's Manual.
2. Position a front carrier frame (Fig. 12) onto each front
cutting unit. Align mounting holes with mounting links
as shown in figure 14.
1
1. Front carrier frame
3. Position rear carrier frame (Fig. 13) onto rear cutting
unit, aligning mounting holes with mounting links as
shown in figure 14.
1. Rear carrier frame
16
Figure 12
1
Figure 13