Adjusting The Gage Wheels; Adjusting The Center Gage Wheels - Toro 30149 Operator's Manual

Adjusting the Gage Wheels

You must adjust the gage wheels in the proper hole location
for each height-of-cut position.
1. After adjusting the height-of-cut, remove the nut and
the washer while holding the stud with a wrench
(Fig. 11).
4
3
2
Figure 11
1. Gage wheel
2. Stud
3. Washer
Note: Do not remove the wheel nut and washer
(Fig. 11).
2. Select a hole position so that the gage wheel is 3/8 inch
(9.5 mm) off the ground for the desired height-of-cut
(Fig. 11).
3. Install the stud nut and the washer (Fig. 11).
4. Repeat the adjustment on the other gage wheels.
1
5
m–4123
4. Nut
5. Wheel nut and washer.
Do not remove.
Adjusting the Center Gage
Wheels
You must adjust the gage wheels in the proper hole location
for each height-of-cut position.
1. After adjusting the height-of-cut, remove the bolt and
the nut (Fig. 12).
3
1
Figure 12
1. Center gage wheels
2. Nut
2. Select a hole position so that the gage wheel is 3/8 inch
(9.5 mm) off the ground for the desired height-of-cut
(Fig. 12).
3. Install the bolt and the nut (Fig. 12).
9
2
m–4124
3. Bolt