Adjusting Center Gage Wheels - Toro 30335 Operator's Manual

Important All four hairpin cotter pins must be in the
same hole location and with the correct number of spacers
for a level cut.
5
1
4
2
Figure 16
1. Carrier Frame
2. Hairpin Cotter
3. Front height–of–cut post

Adjusting Center Gage Wheels

The gage wheels must be adjusted in the proper hole
location for each height-of-cut position.
1. After adjusting height-of-cut remove bolt, washers and
nut (Fig. 17).
2. Select a hole position so the gage wheels are a
minimum of 3/8 in. (9.5 mm) off the ground for the
height-of-cut to be used (Fig. 17).
3. Reinstall the bolt, washers and nut (Fig. 17).
3
4
1
2
m–5230
4. Spacers
5. Back height–of–cut post
3
4
1
Figure 17
1. Center Gage Wheels and
Spacer
2. Nut
23
4
2
m–5213
3. Bolt
4. Washer