Table of Contents
Advertisement
1
Figure 25
1. Pedal
2. Jam nuts
Adjusting the Brake Interlock
Switch
1. Park the machine on a level surface and turn the engine
off.
2. Disengage the parking brake.
3. Remove the knob from the lift lever (Fig. 26).
2
Figure 26
1. Lift lever knob
4. Remove the (3) mounting screws and remove the valve
shroud (Fig. 26).
5. Loosen the (2) nuts securing brake interlock switch to
brake sensor bracket (Fig. 27).
6. Adjust the brake switch until the air gap between the
switch and the parking brake lever link is .060 inches $
.030. (Fig. 27). Tighten the switch mounting nuts.
3
2
3. Control rod
1
2
2. Valve shroud mounting
screws
27
2
1
Figure 27
1. Brake switch mounting
nut
7. Engage and disengage the parking brake to make sure it
does not interfere with the switch.
8. Test for proper operation.
9. Install the valve shroud.
10. Adjust the lift lever guide. Refer to Adjusting the Lift
Lever, Page 27.
Adjusting the Brake Linkage
The brakes have been set at the factory for optimum
performance, but after use and wear an adjustment may be
required.
1. Park the machine on a level surface, turn the engine off,
and block the wheels.
2. Loosen the jam nut on the actuator rod (Fig. 28).
Remove the cotter pin retaining the actuator rod.
Increase or decrease the actuator rod length by rotating
the rod. Install the actuator rod using a new cotter pin
and secure the jam nut.
3
Figure 28
1. Actuator rod
2. Adjustment rod (2)
2. Parking brake lift lever
link
1
4
4
2
3
3. Jam nut (3)
4. Cotter pin (3)
Advertisement
Table of Contents
