Table of Contents
Advertisement
Throttle Control
The throttle control lever (Fig. 9) connects to and operates
the throttle linkage to the carburetor. The control has 2
positions: Slow and Fast. The engine speed can be varied
between the 2 settings.
Note: The engine cannot be stopped by the throttle control.
Hour Meter
The hour meter (Fig. 9) indicates the total hours of machine
operation. The hour meter starts to function whenever the
key switch is rotated to the On position.
Lift Lever
To raise the implement, pull the lift lever (Fig. 10) back; to
lower the implement, push the lever forward. For the float
position, move the lever into the detent position. When the
desired position is attained, release the lever and it will
return to neutral.
Note: The machine has a double-acting lift cylinder. Down
pressure can be applied to the implement for certain
operating conditions.
Parking Brake
To engage the parking brake (Fig. 10), pull back on the
lever. To disengage it, push the lever forward.
2
Figure 10
1. Lift lever
1
2. Parking brake
15
Fuel Shutoff Valve
Close the fuel shutoff valve (Fig. 11) when storing the
machine.
1
Figure 11
1. Fuel shutoff valve
Seat Adjustment
Move the lever on the side of the seat outward, slide the
seat to the desired position, and release the lever to lock the
seat into position.
An additional 2–1/2 inches of forward adjustment may be
attained by , proceed as follows:
1. Remove the (4) locknuts securing the seat slides to the
seat plate.
2. Move the seat/slides to the forward set of mounting
holes in the seat plate.
3. Secure the seat slides to the seat plate with the locknuts
previously removed.
Advertisement
Table of Contents
